The cause of the problem: the system is not synchronized operation; Methods: enter the system Settings, to synchronize operations.
The cause of the problem 1: the controller is not installed the standby power supply or battery failure, unable to charge and discharge. Methods: shielding for electricity or replace the battery....
The cause of the problem 1: communication chip fault line detection module; Processing method: contact with wing rapid after-sales service department, returned to the factory maintenance.....
The cause of the problem 1: the gas detector and M100 approximately module connection bad; Methods: reliable connection again......
The cause of the problem 1: the controller is not installed the standby power supply or battery failure, unable to charge and discharge. Methods: shielding for electricity or replace the battery.
The cause of the problem: the sensor failure; Methods: the change of sensor.
友链: 翼芯红外传感技术(上海)有限公司 安誉 迪盈精密仪器(上海)由有限公司
Copyright 上海翼捷工业安全设备股份有限公司 2019 All Rights Reserved.
沪公网安备 31011202008207号
沪ICP备14022853号